17
Jan
06

Paraffin Treatment Step One: Setting up your paraffin

Put a nice large towel or some newspaper down to cover your workspace. Paraffin doesn’t damage things too much, but it is a pain to scrape off the inevitable droplets. Using whatever appliance you have chosen to warm your paraffin, turn it on, and make sure it is on the lowest setting. Add your block of paraffin if it is not already in there. If you are using a very small crock pot or potpourri warmer, one or two blocks of paraffin should do, but keep in mind, the less paraffin that is in there, the warmer it is going to get. I find it much better to keep the warmer nearly full, adding more when I am finished with my treatment. I have a dedicated crock pot for my paraffin, so it stays in there all of the time, but you can always slip it out after it has hardened (let the paraffin totally harden, then turn it back on for a minute or two, then slip out the block of paraffin), wash your crock pot, and use it for its regular use. Add some oil to your paraffin, but not too much. A ratio of no more
than 1:10 (oil to paraffin) is good. Also add a few drops of your preferred essential oil-again my preference is lavender, but use whatever you like, making sure it is safe to use on your skin. Allow at least a half hour for your paraffin to melt, you will have to determine this by experience. I turn mine on at the beginning of my Spa Manicure, and it is about ready when I am ready to use it. Pull out 2 sheets of plastic wrap, about 2 feet long apiece, and set them to the side.




January 2006
M T W T F S S
« Dec   Feb »
 1
2345678
9101112131415
16171819202122
23242526272829
3031  

Enter your email address:

Delivered by FeedBurner


Badge Farm


0 Responses to “Paraffin Treatment Step One: Setting up your paraffin”


  1. No Comments

Leave a Reply




Close
E-mail It